To only see LAN traffic and no internet traffic, run If you would like to see all the incoming and outgoing traffic for a specific address, enter display filter ip.addr = 1.2.3.4, replacing 1.2.3.4 with the relevant IP address.Įxclude packets from a specific IP address ip.addr != 1.2.3.4.If you would like to see all the incoming traffic for a specific address, enter display filter ip.src = 1.2.3.4, replacing 1.2.3.4 with the IP address the incoming traffic is being sent to.If you would like to see all the traffic going to a specific address, enter display filter ip.dst = 1.2.3.4, replacing 1.2.3.4 with the IP address the outgoing traffic is being sent to.If you want to see all the current UDP packets, type udp into the Filter bar or in the CLI, enter: If you want to see all the current TCP packets, type tcp into the Filter bar or in the CLI, enter: For display filters, see wireshark-filter(4). To do this, click View > Name Resolution and select “Resolve Network Addresses.Note: To learn the capture filter syntax, see pcap-filter(7).
The details of the highlighted packet are displayed in the two lower panes in the Wireshark interface.Ī simple way to make reading the trace easier is to have Wireshark provide meaningful names for the source and destination IP addresses of the packets. The packets are presented in time order, and color coded according to the protocol of the packet. If Wireshark isn’t capturing packets, this icon will be gray.Ĭlicking the red square icon will stop the data capture so you can analyze the packets captured in the trace. This gives you the opportunity to save or discard the captured packets, and restart the trace. Shark fin with circular arrow: If this is green, clicking it will stop the currently running trace.If Wireshark isn’t capturing packets, this icon will be gray. Square: If this is red, clicking it will stop a running packet capture.
0 kommentar(er)
